top of page

Rhinestone designs cut with ScanNCut

I’ve used rhinestone in the past with my Pazzles software so have lots of stones and transfer sheets laying around.

I thought I would have a go at making some designs in Inkscape and converting them in Canvas for the ScanNCut.

I’ve only tried two so far but it worked. I used Pazzles rubber stamp material as my cutting medium, I cut the design with the ScanNCut and then stuck it onto chipboard to make a template.

All I had to do then was pour my rhinestones onto my template and brush them into the holes it worked a treat.

I used a clear transfer sheet to rub over the template to pick up the stones and they are now ready to iron onto a project.

I could only find one of my daughters old black tshirts so I used that to iron the butterfly design onto.




Here is a card I made with the flower.

3 views0 comments

Recent Posts

See All


bottom of page